Use a paper clip or similar tool to clean the exit needle which is located on the inside bottom of the k-cup pack holder. The exit needle may be clogged and will need to be cleaned.After placing the K-Cup pack in the pack holder, make sure the handle is pushed down securely and the LCD control center reads “READY TO BREW” with the BREW button flashing, then press the BREW button.If your Keurig 155 brewer will not brew, try these troubleshooting tips: Repeat until the brewer starts to dispense. Add on additional 2oz of water to the reservoir to ensure the minimum fill level has been met, then press the brew button. The correct time should now be displayed on the LCD home screen.Ī minimum of 6oz of water is required to brew.Similarly, press the M to set the minutes. Press H repeatedly to advance the hour in steps or hold it down to scroll through the hours quickly.The set clock screen will display “DISABLED” if the brewer is new or if electrical power has been interrupted.The time will not be displayed on the LCD unless you have set the time. Replace the water reservoir and perform a rinsing brew with a K-Cup pod.Ĭheck this too: How to Clean Keurig Needles Keurig K150 time is not displayed on the LCD message center The water reservoir may have been removed during brewing.If your brewer is brewing a partial cup, it could be because of the following reasons: Why is my Keurig K-Select Brewing a Partial Cup The brewer is set to turn off automatically 5 minutes after your last brew for energy savings. Check if the Keurig is on energy saving mode.The brewer may not function properly if the electric circuit is overloaded with other appliances. Plug the Keurig on its own grounded outlet.Make sure that you have pressed the power button on your brewer to turn it on.How to troubleshoot a Keurig K-Duo that doesn’t have power or shuts off Contact customer service if all the buttons blink simultaneously. ![]() Contact customer service if the “add water” light continues to be illuminated even after refilling. Make sure the water reservoir is properly seated on its base. ![]() Fill to and not beyond the MAX fill line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |